Hornady Lock-N-Load Control Panel User Manual download pdf (Page 5)

POWDER LEVEL CHECK SETUP (Deluxe model only)

1) Place the Powder Level assembly

into the powder hopper.

2) Locate the wire lead for the

Powder Detect Sensor and plug

the wire harness into the sensors.

3) Verify the wire harness is

plugged in correctly by activating

the sensor and verifying the

corresponding light turns from

green to red on the Control Panel.

4) Adjust the Stop up or down on the Powder Float to the desired level by

sliding the o-rings on each side of the Stop up or down.

OPERATION

• When the level of powder becomes low, the stop on the top of

the Powder Float should trip the sensor.

POWDER SAFEGUARD DIE SETUP (Deluxe model only)

1) Install Lock-N-Load bushing

(sold separately) onto Powder

Safeguard Die.

2) Screw the brass tip nearly all the way

onto the stem by holding the tip and

top knurl.

3) Cycle press to hold at the top of

the stroke (the shellplate is as high

as possible).

4) Install Powder Safeguard Die into

the press next to the powder drop.

Screw down the Powder Safeguard

Die until approximately

⁄8” above the

shell plate.

5) Place a case with the correct

powder charge under the safe guard die. Begin to cycle the press until

resistance is met. The press should lock up (not continue through a

full cycle).

6) Unscrew the brass tip slightly, while holding the top knurl, and try

to cycle the press again. Repeat until the press cycles. Unscrew an

additional turn and verify press cycles.

1 2 3 4 5 6 7 8

No comments

Hornady Lock-N-Load Control Panel User Manual Page 5