Hornady Lock-N-Load Control Panel User Manual download pdf (Page 7)

NOTE: If mounting on a Dillon

press, please contact Hornady at

1-800-338-3220 and request part

number 399274.

4) Lightly tighten the bracket down using

⁄16” hex wrench and a ¼” open end

wrench on the bottom 4-40 Screw and nut.

5) Adjust the Stop up or down on the

Primer Follower rod to the correct

level by sliding the o-rings on each

side of the stop up or down.

OPERATION

• When the level of primers become

low, the stop on the top of the Primer

Follower Rod should trip the sensor.

FAQ

WILL THE CONTROL PANEL FIT ON OTHER PRESSES?

• The Control Panel mounting bracket is designed to ﬁ t onto a 1”

square tubing, however, it may be mounted onto other surfaces using

the through holes on the mounting bracket.

• The Counter and Primer Slide Sensor are not designed to ﬁ t on

other presses.

• The Primer Level Check will ﬁ t onto an RCBS primer tube. If the Primer

Level Check will be used on a Dillon press, please call Hornady Mfg.

at 1-800-338-3220 and request part number 399274.

• The Powder Level Check is designed to ﬁ t on both a standard RCBS

and Dillon powder hopper.

• The Hornady Safeguard Die is designed to ﬁ t on any press with a

⁄8”–14 thread.

CAN THE CONTROL PANEL BE MOUNTED

ONTO A LOCK-N-LOAD

™

WITHOUT A

CASE FEEDER?

• Yes, Hornady recommends

attaching the Control Panel

using the through holes in the

mounting bracket, and Case Feeder

¼”–20 mounting holes on the back of

the Lock-N-Load

AP.

™

1 2 3 4 5 6 7 8

No comments

Hornady Lock-N-Load Control Panel User Manual Page 7