Hornady Lock-N-Load Classic Press User Manual download pdf (Page 6)

- 6 - - 7 -

Mount your new press securely

to a solid level bench.

Position the press on the bench with

the mounting holes far enough back

to provide ﬁrm support and still allow

clearance for the toggle.

Select a shell holder for the

cases you will be reloading.

It is retained in the recess in the top of

the ram by a detent spring. The spring

may at ﬁrst prevent easy change in the

shell holder, but it will smooth out with

a few changes. The detent spring is

easily damaged, so use extreme care if

you must remove it. Refer to pages 10-11

for installing and using Lock-N-Load

®

Bushings.

Insert and adjust the sizing die.

Take note, these presses slightly cam

over to allow you to exert maximum

pressure with reduced effort. Screw die

down until it is ﬁrmly against the shell

holder. The sizing die must be set when

the ram is at the top of the stroke and

not after the ram has cammed over.

INSTRUCTIONS

1

2

3

1

2

3

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments