Hornady RAPid Safe User Manual download pdf (Page 5)

Choose the two RFID entry methods (tags)

you prefer, and program them for use.

Program Buttons

5

RFID Tags

Your RAPiD

™

safe includes ﬁve (5) different

RFID tags, including:

• 3 Bracelets (M, L, XL)

• 1 Key Fob

• 1 Card

The safe’s system can only store up to two (2)

different tags at a time. Only two tags can be

programmed for use. The remaining three tags

will be inert, but can be circulated as one of

the programmed tags if you choose to use

them later, i.e., you can program two bracelets,

or one bracelet and the card, but no more than

two tags may be programmed for use at any

given time.

How To Change Your RFID Tags

The RAPiD

™

safe can store up to 2 tags.

To program these tags:

1. Open your RAPiD

™

safe.

2. Locate the three small program buttons on

the inside right corner.

3. Press the middle (black) button to program

your FIRST RFID tag. Choose one of the ﬁve

tags listed above.

4. When the amber status light on the keypad

blinks, the system is ready for your RFID tag.

5. Place the RFID tag approximately 1/2" over

the RFID reader (H logo) that is located on

the front panel of the safe.

6. Wait for the status light to display green.

7. Remove the tag from the RFID reader on the

front panel of the safe.

8. WITH THE LID OPEN, test the tag by placing

it approximately 1/2" over the RFID reader. If

you do not hear and see the motor activate,

repeat steps 2 through 8.

9. The second RFID tag can be programmed

by pushing the third, lowest (black) button

inside the box and following the steps above.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments